Water Analysis for Hydroponics: Reading the Report and Adjusting Your Nutrient Recipe
Your Source Water Is the First Ingredient in Every Recipe Two farms run the same crop, the same system, the same fertiliser brand. One hits target yields and the other fights deficiencies all season. Very often the difference is not the recipe — it is the water the recipe was dissolved in. Municipal, well, river […]
Nutrient Solution Management: Recirculation vs Drain-to-Waste, EC Drift and Dump Cycles
The Question Behind Every Water Bill and Every EC Problem Should the solution go round again, or should it go to drain? It sounds like an environmental question and it partly is, but on a commercial farm it is really a question about control: recirculation lowers water and fertiliser cost and hands you a more […]
Dissolved Oxygen in Hydroponics: Aeration Design, Targets and Equipment
Oxygen Is the Input Nobody Meters EC, pH and temperature have probes on almost every commercial farm. Dissolved oxygen usually has a story instead: “the pump runs all the time, so it must be fine.” Then a DWC bed loses roots in week five, and the post-mortem finds an aeration system that was sized for […]
Greenhouse Heating for Hydroponics: Sizing, Root-Zone Temperature & Winter Energy Cost
Heating Is a Production Decision, Not a Winter Expense Growers in warm climates build cooling capacity first and treat heating as an accessory. Then a cold snap arrives, root-zone temperature drops out of range, nutrient uptake stalls, and the harvest window moves by two weeks — which costs more than the heating system would have. […]
Hydroponic Water Treatment: RO, UV, and Ozone
Water touches every plant in the facility every day, and it is usually the last input tested before an equipment order is signed. Hydroponic water treatment is a matching exercise rather than a machine purchase: reverse osmosis, UV sterilization, ozone, and staged filtration each remove a different slice of the contaminant list, and none removes […]
Greenhouse Humidity Control and VPD for Hydroponics
Greenhouse humidity control is the discipline that separates a climate which produces from a climate which spreads disease. Humidity sets how fast a crop transpires, how much calcium reaches the growing tip, and how long leaves stay wet after dark — and wet leaves are where grey mould and downy mildew begin. This guide covers […]
Cleaning and Sanitizing a Hydroponic System Between Cycles
By the G&N commercial engineering team · First published: September 2026 · Reviewed for field accuracy Cleaning and sanitizing a hydroponic system between cycles is the single most under-rated step in a commercial greenhouse. Operators who run NFT, DWC, or dutch bucket systems for years will tell you the second crop after a bad sanitization […]
How to Control Algae in NFT and Ebb & Flow Systems
Algae in NFT and ebb and flow hydroponic systems is the most common avoidable failure on a commercial farm. It is not just an aesthetic problem — algae compete with crops for nutrients, host pythium and other pathogens, and form biofilm that clogs drip emitters, channel outlets, and pump filters. On a commercial NFT channel line, the […]
EC, pH, and PPM in Hydroponics: A Grower’s Guide
Two numbers decide whether a hydroponic crop thrives or stalls: EC and pH. Read them right, and the nutrient recipe is balanced to the plant’s actual uptake; read them wrong, and even an expensive A/B mix produces weak roots or tip burn. PPM is the third term you see on every meter and on every […]
Mixing Hydroponic Nutrient Solution: A and B Tanks
A commercial hydroponic farm does not measure each of the thirteen mineral nutrients individually. It mixes two concentrates — A and B — at a measured ratio into a stock tank, then dilutes that into the working reservoir at a target electrical conductivity (EC) and pH. The two-tank system exists for one reason: some nutrients, […]