HDPE vs PVC Greenhouse Mains: Joining, Movement and Repairs

A construction and maintenance comparison of HDPE and PVC greenhouse mains: how each joint reaches full strength, how each moves with temperature, and what a repair costs in downtime.
Parallel Pump Stations: Why Two Pumps Do Not Double Flow

How parallel pump stations really behave: combined flow at full staging, symmetric header layout, check valve and suction traps, and the four readings that prove a station works.
Reading a Pump Curve: Duty Point, Efficiency and Head Loss

A field guide to reading a pump curve: what the H-Q line shows, where the duty point should sit, and the symptoms of a pump running off the curve.
Iron, Manganese and Sulphide in Source Water: What They Do to Drippers and Filters

A project-engineering look at iron in hydroponic water: what iron, manganese and sulphide do to drippers and filters, how to read the water report, and which treatment routes are worth the running cost.
Water Tank Hygiene: Sludge, Covers and the Tank Clean Nobody Schedules

A project-engineering guide to water tank cleaning in hydroponics: where sludge comes from, the signals that say it is time, a full clean-and-disinfect sequence, and the covers and vent screens that keep the next clean far away.
Zone Balancing Valves and Flow Setting: Getting Every Zone to Its Design Number

A project-engineering guide to flow balancing irrigation zones: why measured flows drift from design, which valve type to fit, a commissioning sequence that starts at the most disadvantaged zone, and how to keep the setting locked.
Pressure Boosting and Tank-Fed Supply: When Mains Pressure Cannot Hold a Zone

A project-engineering guide to building pressure from source to system inlet: when boosting is needed, tank versus variable-speed versus packaged constant pressure sets, cycling math and how to test the far zone honestly.
Reservoir Level Control: Float Valves, Level Switches and Auto Top-Up

A project-engineering comparison of the three routes to automatic reservoir level control — float valve, level switch plus solenoid, and transmitter plus controller — with sizing for peak transpiration and the slow-leak failure that quietly dilutes EC.
Hydroponic As-Built Drawings and On-Site Labelling: Knowing What Is Installed

A project-engineering guide to hydroponic as-built records and on-site labelling: what to record, which tag materials survive a wet greenhouse, numbering schemes, and who keeps the record current.
NFT Channel Run Length: How Long One Run Can Be Before Uniformity Breaks

A project-engineering breakdown of NFT channel run length: the four constraints that set the ceiling, planning ranges by channel section and climate, how to measure the inlet-to-outlet gap, and how to section long runs.