Iron, Manganese and Sulphide in Source Water: What They Do to Drippers and Filters

A project-engineering look at iron in hydroponic water: what iron, manganese and sulphide do to drippers and filters, how to read the water report, and which treatment routes are worth the running cost.
Water Tank Hygiene: Sludge, Covers and the Tank Clean Nobody Schedules

A project-engineering guide to water tank cleaning in hydroponics: where sludge comes from, the signals that say it is time, a full clean-and-disinfect sequence, and the covers and vent screens that keep the next clean far away.
Zone Balancing Valves and Flow Setting: Getting Every Zone to Its Design Number

A project-engineering guide to flow balancing irrigation zones: why measured flows drift from design, which valve type to fit, a commissioning sequence that starts at the most disadvantaged zone, and how to keep the setting locked.
Pressure Boosting and Tank-Fed Supply: When Mains Pressure Cannot Hold a Zone

A project-engineering guide to building pressure from source to system inlet: when boosting is needed, tank versus variable-speed versus packaged constant pressure sets, cycling math and how to test the far zone honestly.
Reservoir Level Control: Float Valves, Level Switches and Auto Top-Up

A project-engineering comparison of the three routes to automatic reservoir level control — float valve, level switch plus solenoid, and transmitter plus controller — with sizing for peak transpiration and the slow-leak failure that quietly dilutes EC.
Hydroponic As-Built Drawings and On-Site Labelling: Knowing What Is Installed

A project-engineering guide to hydroponic as-built records and on-site labelling: what to record, which tag materials survive a wet greenhouse, numbering schemes, and who keeps the record current.
NFT Channel Run Length: How Long One Run Can Be Before Uniformity Breaks

A project-engineering breakdown of NFT channel run length: the four constraints that set the ceiling, planning ranges by channel section and climate, how to measure the inlet-to-outlet gap, and how to section long runs.
Hydroponic System Water Volume: The Buffer Behind Stable EC and Temperature

A project-engineering view of hydroponic system water volume: what counts as buffer, litres per square metre by system type, the symptoms of a thin buffer, and the cost of adding tank volume.
Hydroponic System Drain Down and Flush Points: Designing a System You Can Clean

A project engineer’s guide to making a hydroponic system drainable: identifying low points, setting drain-down slope, placing flush points and valves, and planning discharge.
Multi Tier Irrigation Design: Pressure, Drainage and Access Between Levels

A project engineer’s view of multi-tier irrigation design: static head between levels, per-level manifolds and regulation, collecting run-off without cross-feeding tiers, and keeping emitters serviceable.