Vent and Screen Drive Motors: Gearboxes, Limit Switches and Manual Override

A project-engineering view of vent and screen drives: what is inside a drive set, the six faults that stop a house closing, how limits drift, the manual release sequence, and the spares worth holding.
Washdown Hardware: Hose Reels, Foam Units and Cleaning Equipment for the Greenhouse Packhouse

A procurement brief for packhouse washdown hardware: how many reels, which hose bore, why low pressure beats high, what a foam unit really buys, and how colour-coded tools survive an audit.
Peristaltic Dosing Tubes: Wear, Calibration Drift and Replacement

A project-engineering view of peristaltic pump tube wear: comparing tube materials for fertigation duty, the three signs of a failing tube, cylinder calibration, how drift becomes an EC and pH error, and the spares ratio to hold.
Substrate Moisture Control: Drain Percentage, Water Content and EC in Slabs

An advisor’s guide to substrate drain percentage: how it is calculated, target ranges by crop stage, reading slab water content and dry-back, the three EC figures that differ, and the measurement methods worth buying.
Deleafing and Pruning Schedules for Vine Crops: Labour, Airflow and Fruit Load

An advisor’s deleafing and pruning schedule for vine crops: the four jobs leaf removal does, the cost of cutting too hard, weekly leaf targets, wound hygiene, and how to budget the labour.
Iron, Manganese and Sulphide in Source Water: What They Do to Drippers and Filters

A project-engineering look at iron in hydroponic water: what iron, manganese and sulphide do to drippers and filters, how to read the water report, and which treatment routes are worth the running cost.
Water Tank Hygiene: Sludge, Covers and the Tank Clean Nobody Schedules

A project-engineering guide to water tank cleaning in hydroponics: where sludge comes from, the signals that say it is time, a full clean-and-disinfect sequence, and the covers and vent screens that keep the next clean far away.
Zone Balancing Valves and Flow Setting: Getting Every Zone to Its Design Number

A project-engineering guide to flow balancing irrigation zones: why measured flows drift from design, which valve type to fit, a commissioning sequence that starts at the most disadvantaged zone, and how to keep the setting locked.
Pressure Boosting and Tank-Fed Supply: When Mains Pressure Cannot Hold a Zone

A project-engineering guide to building pressure from source to system inlet: when boosting is needed, tank versus variable-speed versus packaged constant pressure sets, cycling math and how to test the far zone honestly.
Reservoir Level Control: Float Valves, Level Switches and Auto Top-Up

A project-engineering comparison of the three routes to automatic reservoir level control — float valve, level switch plus solenoid, and transmitter plus controller — with sizing for peak transpiration and the slow-leak failure that quietly dilutes EC.